Fix My Error Code

Samsung · Washing Machine

Samsung Washing Machine NF Error Code

No water detected during fill

What this error means

nF (also shown as 4E on newer displays) means Not Filling—the inlet valves opened but the water level sensor never saw a rise within the fill window. Samsung aborts before agitation to protect the drum from dry running.

How NF is detected

When NF appears on a Samsung washing machine, the control board has confirmed that water did not leave the machine within the programmed drain window. On Samsung WA45T3400AW, Samsung WA52A5500AW, and similar variants, the drain pump runs for a fixed interval—often three to seven minutes on washers and dishwashers—while a pressure switch or turbidity sensor verifies the tub or sump is empty. If water remains, the cycle stops to prevent spin with a full tub or overflow on the next fill.

Most NF calls are resolved without parts: turn both wall valves fully open. Restricted drain paths mimic pump failure because the impeller spins against a blocked hose or filter. Document whether the pump hums audibly during the drain step; a humming pump with no water movement points to a clogged filter or kinked hose, while silence may indicate a failed pump motor or loose wiring at the harness.

After clearing blockages, run a short cycle and listen at the drain hose for steady water flow. If NF returns on the next load with a clean filter and straight hose, measure resistance at the pump motor connector per the service manual for your model before ordering a replacement pump assembly.

Common causes

  • Hot or cold supply valves closed at the wall
  • Kinked inlet hoses pinched against the rear panel
  • Mesh strainers at washer connections clogged with sediment
  • Drain hose siphoning fill water out through a deep standpipe insert

Step-by-step fixes

  1. 1Turn both wall valves fully open and confirm pressure at nearby fixtures
  2. 2Straighten inlet hoses and maintain clearance from the rear panel
  3. 3Disconnect hoses at the washer, rinse internal screens, and reconnect
  4. 4Verify drain hose standpipe insert is 6–8 inches deep—not deep enough to siphon

When to call a technician

Strong flow at hose ends with dry tub after fill means dual inlet valve or pressure switch replacement.

Affected models

  • Samsung WF45R6100AW
  • Samsung WA52M7750AW
  • Samsung WF45T6000AW

Prevention & maintenance

  • Clean drain filters and hose terminations monthly on high-use washing machines to prevent NF from lint and food debris buildup.
  • Record when NF appears in the cycle and whether it clears after a 60-second power reset on your Samsung washing machine—that detail speeds diagnosis if you call service.
  • Keep the model and serial number from the rating plate when ordering parts for NF; Samsung uses multiple revisions with different harness lengths and board firmware.
  • Photograph wiring connector orientation before disconnecting any component while troubleshooting NF; reversed plugs on pumps and valves cause immediate repeat faults.
Easy10 min